Dcompression therapy has been firmly established in the health care arena for some time now; however, very little has been written about actual clinical protocols for decompression. Various table manufacturers provide some form of "training" with their devices, as do some management companies, but overall, it's up to you to determine the specific protocols. Let's fix that right now by exploring clinical protocols for providing decompression therapy to your patients.
What I will not do here is attempt to cover pull patterns, table designs, traction versus decompression, or marketing. In this author's opinion, lines have been drawn in the sand at nausea on these subjects already. I would rather take a very basic disc pathology case and show what our typical protocol of treatment would be. (Keep in mind that we are talking here only about the "mechanical" component of care. Typically there is also the "chemical component to be dealt with.)
Let's begin by looking at a basic decompression case that comes to our office and how we treat them. When a patient comes into one of our clinics, we do a full physical work-up. If the patient has not taken any radiographs, they are over a year old or their symptoms have changed since the last films, then we send them out for basic plain films. If a spondylolisthesis is demonstrated on film, then we obtain stress films to observe stability. If at this point there appears to be degeneration showing up on the films and the physical exam findings indicate possible disc pathology (usually the patient presents with radiculopathy as well), then we obtain a basic MRI (with contrast if the patient has had surgery; possible CT if hardware is older than 10 years). We also rule out other complicating factors such as facet syndromes, peripheral entrapments, and biomechanical abnormalities that be contributing to the patient's complaints.
If osteoporosis is suspected, we or their family doctor obtains a DEXA scan. If the T score is -1 to positive, it is normal; if it is -1 to -2.4, osteopenia is suspected. Negative 2.5 and greater means osteoporosis is present. In these latter scenarios, our staff MD or the patient's family doctor will get involved and assist in case management. We typically don't do decompression on patients with T scores of -2.3 or greater.
Patients who are candidates for decompression follow a structured program. This program varies from patient to patient. Our plans vary from 15 visits to 25 visits depending on the pathology. We normally have the patient start off four times a week for 1-2 weeks and progress them to three times a week for the duration of the program. We typically don't accept anyone in the program if they cannot adhere to the guidelines. We also never start anyone right before a weekend on the program.
Our typical program consists of an "assembly line approach" that we have set up in our 4,000 square-foot facility. The decompression patient gets adjusted, then treated by assistant staff members assigned to different areas of care, and travel through different departments on each visit. Each department has its own agenda for the treatment of the patient. For the decompression department, we typically increase the distractive force incrementally on each visit until there comes a point that the patient's pain or numbness ceases or drastically diminishes. Then we stay at that poundage for the remainder of the program. This is also a good indicator of when we can start more advanced rehab with the patient.
During the first few visits, the patient receives general modalities to the affected area and start getting passively stretched (ART/PNF). As they are progressing, we move them over to the rehab tracks. Each track consists of several exercises, each progressing in difficulty. We have developed seven standard tracts for lumbar and six standard tracts for cervical cases. We usually start resistive exercise once the patient can demonstrate close to normal range of motion without additional pain. During the tissue resolution and remodeling phases, we are careful not to disrupt or tear any new scar tissue formation.
We typically perform re-evaluations that consist of basic physicals with ROM testing. These are documented and sent to the patient's family MD or referring doctors. In some cases, we send the patient back to their family doctor so they can perform the final evaluation. This makes it clear that we are not "stealing" their patient, which makes them more inclined to send us more referrals. At the end of the program the patient is usually place on a HEP (home exercise program) and seen monthly for general chiropractic care.
In difficult cases such as spondylolisthesis (grade 2 or less), we typically adjust the angle of the force vector so that the primary distractive force is not on the spondylolisthesis itself, but rather the adjacent segment. For example if the disc is L5/S1 and the patient has a grade 1 spondylolisthesis, we typically angle the table so that the primary force vector is hitting L3/L4. This way, it will exert a secondary pull on the affected disc. After a few visits and if the patient is tolerating the treatment, we decrease the angle and start moving into the involved segment directly. This also works well for past surgical cases (non-hardware) such as discectomies and laminectomies.
Our clinic complex features 12 orthopedic surgeons, neurosurgeons and pain management specialists; this case described above is what we would call a typical non-complicating case. There are several complicating factors that can and will present themselves for decompression therapy. These we typically deal with on a case-by-case basis and develop treatment protocols and parameters accordingly. We also find it helpful to do random case reviews to make sure we are providing optimal care. We also review case outcomes and long-term outcomes of our patients.
Over the years, we have managed several thousand decompression cases and are amazed at the results seen when combined with chiropractic care. With the emerging technology, there are table designs that fit basically every clinic, budget and doctor style. There are even decompression tables that provide flexion along with rotation for the patients while undergoing decompression, which we find to be of great benefit for hemi-laminectomies and other types of pathology for which isolation is beneficial.
In future articles, I will attempt to cover the tracts we use and when we use them, as well as the ancillary procedures we use with our decompression cases.
When sports chiropractors first appeared at the Olympic Games in the 1980s, it was alongside individual athletes who had experienced the benefits of chiropractic care in their training and recovery processes at home. Fast forward to Paris 2024, where chiropractic care was available in the polyclinic for all athletes, and the attitude has now evolved to recognize that “every athlete deserves access to sports chiropractic."
It is estimated that 61% of patients with CTS avoid taking surgical options due to postoperative complications and costly surgical procedures. Chiropractic care offers a comprehensive and effective treatment for carpal tunnel syndrome, addressing the condition from multiple angles. Recent studies also have unveiled a game-changing adjunct to chiropractic treatments for CTS: nerve flossing.
Some doctors thrive in a personality-based clinic and have a loyal following no matter what services or equipment they offer, but for most chiropractic offices who are trying to grow and expand, new equipment purchases help us stay relevant and continue to service our client base in the best, most up-to-date manner possible. So, regarding equipment purchasing: should you lease, get a bank loan, or pay cash?
